Banners & Signs Help

Every banner job is a little different, but the goal is always the same: hang it up so it looks sharp and stays put.

All of our banners come with grommets unless you request otherwise, which makes them easy to work with.

For fences or outdoor frames:
Use zip ties or bungee cords through the grommets. Pull them snug but not overly tight. You want the banner to have a little give in the wind so it doesn’t tear.

For walls or flat surfaces:
Screws with washers work best. The washer keeps the grommet from ripping through the fabric. If you don’t want to drill, heavy-duty removable hooks can also work indoors.

For trade shows or events:
Many people use banner stands or pipe-and-drape kits. If you’re not sure what you’ll be working with, bring a pack of bungees and a roll of string. They’re lifesavers when you need a quick fix on-site.

A banner is basically a big sail.

If you’re hanging it somewhere windy:

1. Make sure it’s secured on all sides


2. Leave a little slack so wind can pass through


3. This prevents pulling hard on one edge

For extreme conditions: Consider a mesh banner instead of solid vinyl.

Rain and sun won’t hurt the print, but prolonged exposure can eventually fade colors over time.

If you want your banner to look its best for months on end, take it down when you don’t need it on display.

Vinyl holds up well in heat and cold.

Avoid:

1. Leaving it pressed against hot metal


2. Storing against frozen surfaces

Both can cause creasing or warping.

Folding creates creases that can be tough to get out.

Always roll your banner loosely with the print facing out.

Before storing, wipe your banner down with a damp cloth to remove dust or dirt.

Make sure it’s fully dry before rolling it up. Moisture can lead to mildew or stickiness.

A cool, dry spot is best.

Avoid:

1. Extreme heat (like an attic)


2. Damp areas (like a basement floor)

If you keep it rolled in the shipping tube, it’ll be ready to go the next time you need it.

Don’t panic. Vinyl likes to hold onto creases, but they usually relax once the banner is hanging.

Quick fixes:

1. Lay it flat in the sun for a little while


2. Gently warm the creases with a hair dryer

Never iron a banner. The heat is too direct and will ruin the material.

This usually means it’s only tied at the corners.

Fix: Add more ties or fasteners along the top and sides to spread out the tension.

A banner hung every couple feet will stay nice and tight instead of drooping.

If the banner has been outside for months, UV exposure is the culprit.

There’s no way to ‘re-brighten’ it, but taking banners down when they’re not in use will extend the life of your next one.

For long-term outdoor installs: Consider mesh banners or UV-resistant materials.